Links
Comment on page

Configuring a Connector

Configure a connector to connect to a MobiusFlow® instance

What You Will Need?

  1. 1.
    A device with a web browser such as a laptop, tablet or smart phone, capable of connecting to a 2.4GHz WiFi access point
  2. 2.
    A SIM card removal tool, large paper clip or pin to push the configuration mode button
  3. 3.
    A powered MobiusFlow® connector
  4. 4.
    The connector's Serial Number

Enabling Configuration Mode

If you leave the connector in configuration mode for more than 5 minutes it will automatically reboot and leave configuration mode
The connector's configuration mode can be enabled in two ways:

Using the Configuration button

Using a pin hold in the configuration mode button (inside the small hole to the right of the USB connector) on the front panel for 2 seconds
Release the button and the green LED will flash rapidly
Using your laptop / tablet / smartphone look for a WiFi network with the same name as the connectors serial number
Connect to this network and enter the connector's Config Mode Password. The default is mobiusflow
Open a web browser on your laptop / tablet / smartphone and enter http://192.168.4.1 into the browsers address bar and hit enter
The web browser will show the connector's configuration Home page

Using a Web Browser

This method is only available if you already know the IP address of the connector
Make sure that the connector and your laptop / tablet / smart phone are connected to the same Ethernet network
Open a web browser and browse to <your connector IP address>:8080 e.g. 192.168.1.20:8080
You will need to enter a user name and password. The user name is admin and the password is the same as the connector's Config Mode Password. The default is mobiusflow
After a short delay the web browser will redirect to the connector's configuration Home page