Configuring a Connector

Configure a connector to connect to a MobiusFlow® instance

What You Will Need?

1. A device with a web browser such as a laptop, tablet or smart phone, capable of connecting to a 2.4GHz WiFi access point

2. A SIM card removal tool, large paper clip or pin to push the configuration mode button

3. A powered MobiusFlow® connector

4. The connector's Serial Number

Enabling Configuration Mode

If you leave the connector in configuration mode for more than 5 minutes it will automatically reboot and leave configuration mode

The connector's configuration mode can be enabled in two ways:

Using the Configuration button

Using a pin hold in the configuration mode button (inside the small hole to the right of the USB connector) on the front panel for 2 seconds

Release the button and the green LED will flash rapidly

Using your laptop / tablet / smartphone look for a WiFi network with the same name as the connectors serial number

Connect to this network and enter the connector's Config Mode Password. The default is mobiusflow

Open a web browser on your laptop / tablet / smartphone and enter http://192.168.4.1 into the browsers address bar and hit enter

The web browser will show the connector's configuration Home page

Using a Web Browser

This method is only available if you already know the IP address of the connector

Make sure that the connector and your laptop / tablet / smart phone are connected to the same Ethernet network

Open a web browser and browse to <your connector IP address>:8080 e.g. 192.168.1.20:8080

You will need to enter a user name and password. The user name is admin and the password is the same as the connector's Config Mode Password. The default is mobiusflow

After a short delay the web browser will redirect to the connector's configuration Home page