BLE Devices

Usage of MobiusFlow BLE devices service to decode incoming BLE raw data and populate MobiusFlow objects.

The BLE service works in conjuction with the following feeder services:

• BLE Gateways

• Juniper Mist

• Aruba Connectors

All three of these services forward undecoded BLE advertisment data to the MobiusFlow hub (via a BLE_RX broadcast command). The BLE Devices service listens for this data. If the service detects data for a device that matches one registered with it, it will decode the data and populate the corresponding MobiusFlow object.

Service Configuration

Inititally, add the service from the service library:

Service Settings

The service itself has no custom settings. When run, it will automatically listen for data from all feeder services without any configuration.

BLE Devices / Objects

Every BLE device must be added to the service as an object. Initially, view the objects on the BLE devices service by clicking on it's tile:

Here your BLE devices are shown in the region marked here in green. Add new devices from the objects library marked in red here.

When you add a new device, you must add its BLE Address so the service knowns where to send incomming data:

Finally, ensure the service is started:

Now as data comes in from feeder services, the corresponding MobiusFlow objects will be populated: